Home > News > Content
How To Thoroughly Clean The Foaming Agent Gun?
Oct 11, 2017


In the construction of frequently used foam engineers, foaming agent gun is a very good tool, which is used for filling, convenient operation, filling agent can avoid a lot of waste in the foaming process.

But in use, the foaming agent gun cleaning is an indispensable step, many of my friends have such experience, if not timely cleaning gun, foaming agent, foaming agent gun can easily be partially or completely blocked, causing the sealant to play out or control is not good, so things are more trouble, only the gun slowly opened the care, time-consuming. In the worst case, the foam gun was laid off early.


So how do we clean the foaming gun?

Look at our usual practice:

The gun type foaming agent from above the gun down, and then use the cleaning agent interface, then the bottle cleaning agent installed through the interface, then pulled the trigger continuous several times until the muzzle jet cleaning agent, liquid hardly what color, remove the cleaning agent to the cleaning process, even if the end.


So is this completely cleaned up?

The fact tells us, it's not like that. I believe many of my friends also have this kind of confusion, they each used foaming agent gun do after cleaning, but a new gun in a few times, the total blockage in different degrees, and even affect the quality and progress of construction, this only shows that our cleaning is not thorough.


Where's the problem?

We know that in the process of using foaming agent gun, sealant will continue in the deposition chamber, with the passage of time, gradually hardening and strong adhesion on the pipe wall, in such a stubborn, wash a few seconds or tens of seconds, can only be hurt fur, do not touch fundamentally, a considerable part of the sealant, acts as the "nail households", still "Lai" in the chamber.

Here, I believe many of my friends have a solution method for residual sealant foam gun, these "hateful" bubbles in the cleaning agent does not go on, that is, we should thoroughly clean the gun foaming agent about tips:

After the bottle cleaning agent installed first, pulled several trigger, most of the cleaning chamber sealing agent, cleaning agent and then let the infiltration time in the chamber (long time specific, authoritative statement, from the manufacturers for five or six minutes, and finally, the absolute fix) pulled several times to trigger. The residual filling agent in gun washed clean, then foaming agent gun cleaning quite thoroughly.


With this little trick, we may as well try, we believe that it will certainly bring you convenience in the construction process!


Zhuji Meijiang Hardware Factory
Add:Jiangdong Road East Diankou Town, Zhuji City, Zhejiang provice
Tel:+86-575-87865037
Fax:+86-575-87068255
Ph:+8613616505798
E-mail:
Ice@zjmeijiang.com