Home > Exhibition > Content
Introduction of a foaming gun
Jul 28, 2018

1. Shake the foam tank up and down for 1 minute before use.

2. turn the tank into the adapter (not too tight!)

3. when the ejector starts working, press down the trigger and let the foam flow for 10 seconds. The foam is filled with elongated tubes. Drive out the remnants of the air.

4. fix the needle on the nozzle.

5. when the new flow control device is used, the syringe with syringe should be erected.

6. foam output is regulated by the plate machine and controlled by the flow adjustment screw. If the screw is tightened and the syringe board is locked, the adjustment screw is loosened by not turning more than three circles.

7. when changing the tank, we try to shake the new tank and unload the empty tank. Quickly (within a minute) install a new structural foam tank.

8. changing cans must be fast so as to prevent foaming from hardening in adapters.

9. when necessary, replace the needles that make the hardened foam caking.

10. quickly unload the tank when cleaning the foaming gun. The cleaning agent is turned upside down to the adapter of the foam gun, and the plate machine is screwed for thorough cleaning.

11. foam hardening residue on the front lip of the foam gun is removed from the pie or the like. Remove the outer edge of the long tube with a metal brush or knife.

Zhuji Meijiang Hardware Factory
Add:Jiangdong Road East Diankou Town, Zhuji City, Zhejiang provice
Tel:+86-575-87865037
Fax:+86-575-87068255
Ph:+8613616505798
E-mail:
Ice@zjmeijiang.com