Home > Exhibition > Content
Instructions and precautions of foam gun
Apr 30, 2017

Instructions and precautions of foam gun

Instructions

1 before use: the foam tank up and down for up to 1 minutes.

2 screw the tank into the adapter (not too tight!)

3 when the ejector starts working, press the trigger to let the foam flow for 10 seconds. The foam is filled with an extension tube. From the residual air.

4 fix the needle to the nozzle.

5 when the flow control device is used, the syringe with the tank should be kept upright.

6 foam output with the machine to adjust and use flow adjustment screw control, if the adjustment screw tightened, the injector plate is locked not to rotate more than three laps to loosen the adjustment screw.

7 try to shake the new tank when you change the tank, remove the empty pot. Quickly (within one minute) to install a new structure foam tank.

8 the tank must be fast enough to prevent the foam from hardening in the adapter.

9 replace the needle of the hardened foam when necessary.

10 in the cleaning foam gun, fast unloading tank. The cleaning agent is turned upside down to the foam gun adapter, and the trigger plate is thoroughly cleaned.

11 foaming gun front mouth foam hardening residues with the removal of faction or the like. Clean out the long tube with a metal brush or knife.

Matters needing attention

1 slow down the tank

2 do not "own" repair, so as not to damage the syringe

3 do not use hard ware adapter

Zhuji Meijiang Hardware Factory

Add:Jiangdong Road East Diankou Town, Zhuji City, Zhejiang provice

Tel:+86-575-87865037

Fax:+86-575-87068255

Ph:+8613616505798

E-mail:Ice@zjmeijiang.com