Home > Exhibition > Content
How to fill foam filler with foam gun when home
Dec 22, 2017

Usage:

1. Take a polyurethane foaming gun and wash it with polyurethane cleaner to ensure smooth flow.

2. Take a bottle of foaming agent, hold the middle of the tank by hand, and shake at least 20 times along the transverse direction of the tank. Make sure that the prepolymer is fully mixed.

3. Remove the protective leather cover of the valve in the foaming agent, remove the cleaning agent from the foaming gun, and put the foaming agent on the interface of the foaming gun.

4. Clench the foaming gunner to ensure that the tank is placed above and the foaming gun is below the tank and open the flow control valve at the rear of the foaming gun.

5. The gun is pointed at the bottom or the inside of the part to be filled, then gently pull the trigger and start construction. The flow mediating valve behind the foaming gun can be adjusted to the appropriate flow.

6. After a can is sprayed, if you want to fill it, you can immediately remove the empty can and re-install the foaming agent according to the method of the third point and continue the construction.

7. After the completion of the construction, remove the container and replace the foam gun with special cleaning agent, so as to avoid the residual material solidification and blockage of the foaming gun.

Zhuji Meijiang Hardware Factory

Add:Jiangdong Road East Diankou Town, Zhuji City, Zhejiang provice

Tel:+86-575-87865037

Fax:+86-575-87068255

Ph:+8613616505798

E-mail:Ice@zjmeijiang.com